Set travel RMG 290-G2 (G1)

Using Turnigy I6 or Fly Sky TX

TX refers to Transmitter RX refers to Receiver.

Turn on make sure winch is responding to TX if not check it is correctly bound to RX.

Place Orange setup wire onto Channel 5 Signal pin on RX

On TX use top LH knob this is Channel 5.

Turn knob fully left and Sail stick fully down.

Turn knob fully right you will hear a ring tone immediately push sails fully up. Turn knob back fully left you will get ring tone immediately pull sails fully down you will get ring tone.

Winch is now ready to set travel to desired fully out position. (the winch will run slower in this mode).

Turn knob fully Right you will get ring tone now turn knob fully back Left you will get ready to use tone Winch is now set.

Leave Orange setup wire on channel 5 on RX this will stay on and winch travel can be set at anytime without the need to go inside the boat.

If the setup is being done for the first time the DRUM needs to be removed.

If using other brands of TX select an unused channel to do setup.

G rax