Download Wireless N Exterior Access Point - D-Link .PDF
437412 Downloads
8.21 MB .pdf
D-Link DAP-3410 User Manual 36 Section 3 - Configuration Filter The Access Control filter section can be used to filter network access by machines based on the unique MAC addresses of their network adapter(s). Destination Enter the specific port to filter on the destination Port: network. The 2 major improvements over WEP: • Improved data encryption through the Temporal Key Integrity Protocol (TKIP). 11a wireless network interface and is within range of the AP. Click on a network (displayed using the SSID) and click the Connect button. Group Key Select the interval during which the group Update: key will be valid. • Convenient Installation - The DAP-3410 features a wall/pole mount in the rear for easy setup on poles or walls. (Encryption option only available with Open System setting) Key Type: Select either HEX or ASCII as the key type. MAC Address: Click the Add button to add the new MAC address to be filtered. D-Link DAP-3410 User Manual 75 Section 6 - Troubleshooting Troubleshooting This chapter provides solutions to problems that can occur during the installation and operation of the DAP-3410. Network Service Set Identifier (SSID) is the name Name(SSID): designated for a specific wireless local area network (WLAN). Destination Enter either the destination network, or the Net/Mask: subnet mask that will be used in the static route. At a 2-degree angle it looks over 42 feet (14 meters) thick! Position devices so that the signal will travel straight through a wall or ceiling (instead of at an angle) for better reception. Beacon Beacons are packets sent by an access point Interval: to synchronize a wireless network. The AIFs ensures that multiple access points do not try sending data at the same time but instead wait until a channel is free. AIFS: The Arbitration Inter-Frame Spacing (AIFs) specifies a wait time (in milliseconds) for data frames. Key Size: Select 64 Bits or 128 Bits for your key size. The port which the console will use for connections can also be specified. For a detailed description of the WPA-Personal parameters, please go to page 19. RIP Service: Select to either Disable or Enable the AP from offering RIP routing services