for technical assistance 1.800.743.8259

Download for technical assistance 1.800.743.8259 .PDF

498903 Downloads

5.36 MB .pdf

Maximum inlet hot water temperature is 180°F (82°C). Confirm snap ring is inserted properly on groove of stem. Check your installation for compliance with plumbing and other applicable codes. FINISHED WALL 1 2 FRONT OF INSTALLATION GUIDE FIGURE 3 4 5 SV16 FIGURE 4 6 3 4 SV16-LVR FIGURE 5 SV16 7 5 9 8 12 9 FINISHED WALL DETAIL "A" 10 11 FIGURE 6 Acorn Controls Division of Acorn Engineering Company®, A member of Morris Group International™ Manual #7802-116-000 Page 4 of 9 Date: 09/01/16 SV16 Installation & Operation Manual VALVE TRIM INSTALLATION CONTINUES: 9B. Ÿ Implement an annual maintenance program to Ÿ Maximum water pressure is 125 psi (8. This warranty is in lieu of all other warranties expressed or implied. Turn back counterclockwise slowly until the water flow completely stops. NOTE: Insure that outer gasket 4 gap is towards bottom of escutcheon 5. Ÿ To ensure proper installation, review the manual thoroughly to verify rough-ins before beginning any work. NOTE: If handle 10 does not sit properly in escutcheon, remove stem insert 12 and rotate so it sits on upper or lower ledge. Please leave this documentation with the owner of the fixture when finished. Wall anchors, screws, nuts and washers as required. If temperature is not satisfactory refer to TEMPERATURE ADJUSTMENT page 6 step 4. Ÿ Installation and field adjustment are the responsibility of the installer. Installation of this valve shall be in accordance with Uniform Plumbing Code. Prior to installing valve trim, check for proper operation of valve, on/off, flow and high temperature limit. Rotate external stem 21 with handle counterclockwise measuring water temperature with a thermometer until the high limit temperature is reached. Inlet connections are combination 1/2” NPT and 1/2” sweat. Valve assembly must be drained prior to being subjected to freezing temperatures. For 2” x 4” wall construction position, shower valve so that center of inlet ports are 1-3/8” ± 1/4” (50mm ± 6mm) from finished wall, ensuring the outlet port marked “T” is facing down