Download Kodak C360 Digital Camera User Manual .PDF
6546604 Downloads
5.16 MB .pdf
Muffler and engine become hot and can cause a burn. Assembling Your New Edger Positioning the Edger Handles Remove and discard any packaging cardboard that may be present between the upper handle and the lower handle. Stopping The Engine To stop the edger’s engine, release the blade control. Thoroughly inspect the area where the all times until fueling is complete. 5 Operation And Adjustment The operation of any edger can result in foreign objects being thrown into the eyes, which can result in severe eye damage. MTD does not extend any warranty for products sold or exported outside of the United States, its possessions and territories, except those sold through MTD’s authorized channels of export distribution. As with any type of power equipment, carelessness or error on the part of the operator can result in serious injury. With blade control lever in START position, make a pass along area to be edged before proceeding to the next notch. Drain gasoline and refill tank with clean, fresh gasoline. WARNING: This control mechanism is a safety device. Curb Height Adjustment Lever Starter Rope / Recoil Starter The curb height adjustment lever is found on the rear portion of the edger. If situations occur which are not covered in this manual, use care and good judgment. Read this operator’s manual carefully in its entirety before attempting to assemble this machine. IMPORTANT: Using the primer to restart a warm engine after a short shutdown is usually not necessary. Install the replacement edger blade and the flange nut removed earlier. Coat the edger blade with chassis grease to prevent rusting and corrosion. Pivot the upper handle upward until it snaps into place. To avoid personal injury or property damage use extreme care in handling gasoline. 11 Off-Season Storage Notes Observe the following when preparing the edger for long-term storage: 1. are familiar with these rules of safe operation 5