Download Type T 110 NOVA T110 NOVA .PDF
1589160 Downloads
3.69 MB .pdf
34 USE OF TENONING TABLE OPT Tenoning table (D fig. The tool adjusting shall be carried out with machine off. The position where to install the machine shall be well lightened (at least 500 LUX), proper for the connection to the power line, to the suction system and for maintenance operations. 5- Do not machine pieces with defects (deflections, clefts, knots, metallic parts, . This operation may not be carried out without the proper anti-kickback guard. The fence may be fixed to the support both on the right side and on the left side of the operator according to the spindle rotation direction and may be set to the right height and locked by lever (14). 5 PIECE GUIDANCE It is important to use: a) the hood-fence unit to ensure during the milling the proper piece guidance. 12 CLIMB MILLING When possible it is necessary to avoid the clim milling. 34P supplied in accessories bag) to support (L) with proper screws. The guard is equipped with 2 stops for cutters of diameter between 120 and 150 mm. 8 FZ_NGB20 T 110 NOVA MAINTENANCE T 110 NOVA FZ_nGB20 20. When you have to replace these bearings directly apply to SCM Ufficio Ricambi. To reset the button turn it to the arrow direction. Proceed as follows: 1) 2) 3) 4) 5) 6) 7) 8) 9) Press the emergency button Release the brake by turning selector (E OPT ) to . Special devices not indicated in the price list, available only upon request and after technical check. During the machine positioningyou have to consider that the in case of longer pieces a sufficient room is required to avoid squashing points towards the fixed parts of the working envinronment as walls, columns etc. Turn the starter to 0 for stopping the motor 0 4 I I Buttons for starting and stopping the spindle Press it to start the spindle: pilot lamp lit. 13A) of the tool of the spindle without rings is at the height of worktable (2 fig. Make sure that no contact with tenoning table is possible Check that the max. 24E) give the speed selection according to: - spindle diameter d1 fig