CHAUVET DJ COLORband Q3BT User Manual

Download CHAUVET DJ COLORband Q3BT User Manual .PDF

9057500 Downloads

3.21 MB .pdf

Always disconnect the product from the power source before cleaning or replacing the fuse. Press <MENU> repeatedly until C shows on the display. Use <UP> or <DOWN> to select a sound-active program, from Snd1–8. 3 Setup Mounting Before mounting the product, read and follow the safety recommendations indicated in the Safety Notes. Press <FADE> repeatedly to cycle through P5–8. Only loosen or tighten the bracket knobs manually. Automatic Program To run a program on the COLORband Q3BT, follow the instructions below. Rigging • Before deciding on a location, always make sure there is easy access to the product for maintenance and programming. Press <+> or <–> to increase or decrease the speed of the program. Softly drag any dirt or grime to the outside of the transparent surface. Never disconnect the product from power by pulling or tugging on the cord. Press <MENU> repeatedly until S shows on the display. Use <UP> or <DOWN> to select the starting address, from d001–509. Connect the DMX input of the first slave product to the DMX output of the master product. Use <UP> or <DOWN> to select a static color, from C 1–15. IRC-6 Infrared Remote Control The COLORband Q3BT is compatible with the IRC-6 infrared remote control from Chauvet. Use <UP> or <DOWN> to increase or decrease the selected value, from 0–255 (for red, green, or blue) or from 0–100 (for strobe rate). 3 Page 13 of 14 Contact Us Contact Us General Information Technical Support Chauvet World Headquarters Address: 5200 NW 108th Ave. Press <MENU> repeatedly until dIM shows on the display. • Make sure adequate ventilation is provided around the product