030 and 031 The Half-Time Key Machines

Download 030 and 031 The Half-Time Key Machines .PDF

4757093 Downloads

4.85 MB .pdf

(which is 030 or 031), your registration number (see below) and the part number desired (see pages 6 to 8). Use only genuine ILCO UNICAN replacement parts on this machine! INTRODUCTION Congratulations! You’ve purchased a superior key cutting machine. 001" so rotations of the collar can be measured. When two keys are cut, only the bottom key will have burrs and require deburring (brushing). 055" thick 5 EXPLODED VIEW 6 EXPLODED VIEW 7 EXPLODED VIEW PARTS LIST Refer to pages 6 and 7 for illustrations. It properly identifies your model and assures you will receive correct parts, if and when you require replacement parts. To perform the adjustments, insert the same type key blank into each vise jaw. Remove the key(s) and brush off any burrs by running the key under a brush or a small file. Also, the machine can be bolted to the work bench for stability. Repeat the previous steps for all remaining cuts in the pattern key. Note the cutter, it should be touching the left key blank. Note the keys gauge from the bottom shoulder, using the same key stops required for Mogul keys. The person wants to cut the large paracentric cylinder key (Mogul). If you decide to bolt it down, make sure the surface is level and all four bolts or screws are tightened equally. Install the CU30-M cutter, replac- (131477), Screws (174080). Registration and Serial number is 2 Any and all warranties made by ILCO UNICAN on any machine, product, or component thereof shall be effective only if and for so long as the buyer complies with all payment obligations pursuant to the buyer’s accepted and acknowledged order. Clamp the pattern key (original) in the right vise jaw. DO NOT DESTROY OR DISCARD THIS VALUABLE SHIPPING CARTON. Identification of the parts in 030Since these large paracentric keys gauge like conventional CK is as follows: Cutter (CU30-55), Key Stops (030-20), size cylinder keys, different key stops are required on the Screws (030-53). For cutting the duplicate key, the carriage is shifted sideways to the left, with the key blank passing across the cutter, just as with conventional duplicating