Download Pizza Kit for Kettle Grill Owner`s Manual .PDF
6134269 Downloads
3.65 MB .pdf
5 in grill kit FRONT Align top and bottom holes on back edges of side panels 3. PIZZACRAFT® DOUGH RECIPE Ingredients • 3 cups pizzacraft® “00” pizza flour • ½ teaspoon active yeast • 1 ½ teaspoons kosher salt • 1 ½ cup water Combine all ingredients in a mixing bowl and stir to form a rough, shaggy dough. 5” MASTERBUILT PRO: Set the hood onto your Pizza Kit so that the back edge of the grill hood channel seats into the clips opening upward (as shown in FIG. 3) and the hood rim rests comfortably on the front support tabs. Clips near front edge and clip in rear panel are mounted with the opening facing down, while the clips near the middle of side panels are mounted with the opening facing up. When you are ready to use, remove from the refrigerator and shape into 2 or 3 smaller dough balls. Intended for use with charcoal style kettle grills only. (1) Bend edge tab outward to expose u-channel and (2) slot flat edge into u-channel then (3) bend tab back over u-channel into original position to lock panels together. Do NOT leave children, infants or pets unattended near your kettle grill with the PizzaQue® Pizza Kit while it is still HOT. Check to confirm the bottom edge of the assembly sits flat. If so, slide your pizza screen or aluminum pizza peel between the stone and pizza. angled flat FRONT rear panel shown in solid black rear panel on OUTSIDE of left side panel rear panel on INSIDE of right side panel CONNECTION DETAIL TOP VIEW 6 3. PM0412 Flexible Dough Rolling Mat: Easy to measure and roll perfectly sized pizza crust. Following the set up procedures closely will allow you to cook 5 to 7 pizzas consecutively with approximately 10 pounds of fuel. Place onto a floured mat, cover with plastic wrap and let rise again for approximately two hours or until it feels warm to the touch. Always allow Pizza Kit and grill to cool completely before handling. CM4043 Wood Chunks: Aromatic hickory and mesquite wood chunks are classics in smoking and barbecue. Do NOT remove ashes until charcoal is completely burned off. 5” CLIP CONFIGURATION: Attach side panel clips and rear panel clip (Qty 5 total 2 on each side panel and 1 on the rear panel). 5” WEBER: Set the hood onto your Pizza Kit so that the top edge of the wire door frame seats into the channel on the edge of the hood