Download nPP16 IM .PDF
932423 Downloads
8.22 MB .pdf
For switching a lighting load, an internal 16A latching relay is used. Left alone, the zone will assume default operation and can be programmed via its’ devices’ push-buttons. Channel tracking settings can be programmed for each device via the unit’s push button, SensorView, or a locally connected Graphical WallPod (nPOD GFX) station. To provide system power, the power pack transforms Class 1 line voltage (120-277 VAC) to Class 2 15 VDC. Sensors and WallPods typically require less than 3mA of bus power each; therefore, an nPP16 IM can usually power its entire lighting zone and will often contribute power to other zones. CURRENT MONITORING OPERATION Electrical current flowing through the device’s relay and the nominal voltage (120 or 277 VAC) are measured by the device. ORDERING INFO nPP16 IM [DEFAULT MODE] [TEMP/HUMIDITY] OPTIONS TEMP/HUMIDITY DEFAULT MODE Blank = Auto On SA = Manual On Blank = Standard LT = Low Temp Revised 7. All nLight switches and sensors can be configured to broadcast (i. 2 for default settings and directions on programming the sensor via the push-button. BASIC OPERATION An nPP16 IM Series power pack’s transformer supplies up to 40mA of bus power from each of its two RJ-45 ports. TN-620-01 900 Northrop Road, Wallingford, CT 06492 • 1. The nLight nPP16 IM Series power pack adds current monitoring to the standard nLight nPP16 Series power / relay pack. For simplifying installation, power packs have an elongated chase nipple that allows them to be attached either directly through a ½” knockout into a junction box, or inside an adjacent box for meeting specific local code requirements in ceiling plenums. LIMITATIONS AND EXCLUSIONS: This Warranty is in full lieu of all other representation and expressed and implied warranties (including the implied warranties of merchantability and fitness for use) and under no circumstances shall Sensor Switch, Inc. nPP16 IM POWER / RELAY PACK with INTEGRATED CURRENT MONITORING SPECIFICATIONS FEATURES Communicates w/ nLight Network Self-Contained Relay Switches Line Voltage Load Measures & Reports Current through Relay to SensorView Measures Nominal 120 or 277 VAC Supplies 40mA of Bus Pwr / RJ-45 port Remotely Configurable/Upgradeable Push-Button Programmable Configurable Relay Logic Green LED Indicators Extended Chase Nipple PHYSICAL SPECS SIZE (not including ½” chase nipple) 3. By default, an nPP16 IM is configured to follow all occupancy, photocell, and switch commands arriving on local channel 1. be liable for any incidental or consequential property damages or losses. Once linked to a Gateway, directly or via a Bridge, the zone becomes capable of remote status monitoring and control using SensorView software. 65 cm) WEIGHT 6 oz MOUNTING ½” knockout COLOR White nLIGHT NETWORK PORTS 2 RJ-45 ELECTRICAL SPECS OPERATING VOLTAGE 120-277 (single phase) RELAY LOAD: 16 Amps (latching) OUTPUT VOLTAGE/CURRENT 15 VDC, 40mA / port MOTOR LOAD: 1/2 HP WIRES 16 AWG (2), 18 AWG (2) ENVIRONMENTAL SPECS OPERATING TEMP 14º to 122º F (-10º to 50º C) RELATIVE HUMIDITY 20 to 90% non-condensing ROHS COMPLIANT SILICONE FREE OTHER UL and CUL Listed Plenum Rated Title 24 Compliant 5 Year Warranty Assembled in the U. , upon prompt notice of such defect, will, at its option, provide a Returned Material Authorization number and repair or replace returned product