Download Eaton PT18M-V-K 1800-Watt 15 Amp 125-Volt 5-Button Minute Timer with Auto-Off, Ivory Installation Guide .PDF
6141551 Downloads
1.50 MB .pdf
Secure Timer into the wall box using two mounting screws provided. • The same process should be repeated for each button to be programmed. CWD will repair or replace the defective unit, at its option. The timer red wire will connect to the wire which goes to the light fixture. To put the device in this mode, press and hold button 6 for 2 seconds until the LED on button 6 starts blinking and then release the button. For use ONLY with permanently installed fixtures of these types: Incandescent/Halogen, Magnetic Low Voltage (MLV), Electronic Low Voltage (ELV), Fluorescent, Compact Fluorescent, LED 6. (ASPIRE Model Shown) Button 1 Button 2 Button 3 Button 6 Button 4 Button 5 OPERATION INSTRUCTIONS • To turn on the load press any of buttons 1 through 5. NO AGENT, REPRESENTATIVE, OR EMPLOYEE OF CWD HAS AUTHORITY TO INCREASE OR ALTER THE OBLIGATIONS OF CWD UNDER THIS WARRANTY. Must be installed and used in accordance with all applicable electrical codes. If the problem persists, call the customer service hotline at 1-866-853-4293 between 8:00 A. Install the timer loosely using the mounting screws provided. To re-program the timer, there are 2 methods - a quick mode that sets predefined values to the timer, and an advanced mode that allows the user to program each button separately. The load will turn on and stay on until the user momentarily presses button 6 again to turn it off. Use only #14 or #12 copper wire with these devices. Wiring the device with the power on may cause permanent damage to the device and void the warranty. The load should turn ON and the corresponding LED should turn ON. The LED on button 6 will temporarily blink to indicate that programming has been completed. Installing 5 Button Timer Refer to the wiring diagram and install the timer according to these directions. CWD will not be responsible under this warranty if examination shows that the defective condition of the unit was caused by misuse, abuse, improper installation, alteration, improper maintenance or repair of damage in shipment to CWD. 9591 and PT18H) • Automatically turns off lights/fans after preset time • LED indicates preset time selected and count down • An LED indicates when the timer is about to turn off • Dimmed LED to act as a locator in the dark • Easy programming mode with 1 minute increments • Bypass mode that allows the timer to stay on permanently