Download Toshiba EO1-33087 Barcode Reader User Manual .PDF
5926828 Downloads
3.70 MB .pdf
The main indicator lamp statuses and the corresponding printer statuses are shown inside the top cover. To insure the best operating environment, and to assure the safety of the operator and the equipment, please observe the following precautions. However, please note that TOSHIBA TEC shall have no liability for any damage of any kind sustained during transportation of the product. EA1- 6 APPENDIX 2 INTERFACE ENGLISH VERSION EO1-33087 APPENDIX 2 INTERFACE APPENDIX 2 INTERFACE Interface Cables To prevent radiation and reception of electrical noise, the interface cables must meet the following requirements: • Fully shielded and fitted with metal or metallized connector housings. The B-EV4T Series printer must be powered by the EA10953 AC adapter. Open the Ribbon Access Cover and remove the ribbon. Strip mode (Option): When issued in the strip mode, labels are automatically removed from the backing paper each time a label is printed. 7) The cuter blade has reached the end of its useful life. The SD Cards are available from your nearest TOSHIBA TEC representative or TOSHIBA TEC Head Quarters. To turn ON the printer power, press the power switch as shown in the picture below. 2 Status Lamp Color Green Green Green Green/Red Status Lights up Flashing fast Flashing slowly Flashing slowly Red Lights up Red Flashing fast Red Flashing at medium speed Flashing slowly Red Orange Flashing fast Orange Flashing at medium speed None Unlit Cause Solutions Stand-by Communicating with a host Printing is temporarily stopped (paused. For information regarding TOSHIBA TEC-approved media, please contact a TOSHIBA TEC authorised representative. NOTE: Do not forcibly move the Media Guides by hand, as doing so may break the Media Guides. Xmm Back feed amount fine adjustment value PARAMETER: [PC-850][0] - Character code selection and Font “0” selection [9600][8][1][NONE][2] - Baud rate, Data length, Stop bit length, Parity, and Transmission control of RS232C [ON][AUTO][FEED][B0]- Forward feed wait function, Control code, Feed key function, and Euro code X-COORDINTE ADJUST: +XX. Ribbon Supply Roll Spring Guide Wheel (Supply side) (2) Fit the left side of the core of the Ribbon Supply Roll to the Guide Wheel, aligning the notch of the ribbon core with the protrusion of the Guide Wheel. Push the Media Holders against the media roll to firmly hold it, then slide the Media Holder Lock Switch to the Lock (▼) side. Then, contact your authorised TOSHIBA TEC representative for assistance. Request Regarding Maintenance • Utilize our maintenance services. Since the power cord is not enclosed in this printer, please purchase a proper one after referring to page 1-2. 4 Connecting the Cables to the Printer CAUTION! Be sure to connect the serial or parallel cable while the printer and the host computer are power-off states