COHU, INC. ELECTRONICS DIVISION

Download COHU, INC. ELECTRONICS DIVISION .PDF

7276075 Downloads

5.19 MB .pdf

6X-1027a 3950 iVIEW INSTALLATION AND OPERATION iVIEW POSITIONER (115 V ac Version) CA-297D Cable (iView to 9300 Local Control Panel) Camera Input power is directly routed to Camera connector for use by iView NOTE: This panel is optional. For mounting to a pole, the four mounting bolts are provided by a bracket. 3 3950 iVIEW Base is permanently attached to the iView Figure 4. This cable has an ac power plug, BNC video connector, and stripped leads for data connections at the junction box. DATA 2 pair, twisted with overall shield, 26 AWG minimum (Belden 8723 or equivalent) Pin functions for the 24 V ac version of an iView are not shown in this manual. The enclosure protects against salt, grime, dirt, and moisture. Proceed as follows for installation on a pedestal: 6X-1027a 11 INSTALLATION AND OPERATION 3950 iVIEW Figure 8. Install a weather tight gasket between the arm and the surface of the wal — if required. Integration control plus a built-in video storage card provides full color continuous video even at very low light levels. All warranty repairs will be performed at the factory or as otherwise authorized by Cohu in writing. The wrap then should be squeezed slightly together by hand to remove air gaps and ensure it has moulded itself to the cable and connector. Tensioning tool (pole mounting) (type 7411411-001) 3. This can be used to interpret an existing model number. This provides greater integration flexibility for the designer and more dynamic camera control for the operator 1. The arm is typically supplied with this adapter plate already installed. 6X-1027a If this is not the required address for this iView, then change the address to the required number and click on “Set Address. This can be obtained at no cost from either the cohu-cameras. Before the address can be set or any other setups made, it is necessary to establish communications with the iView. The positioner speeds are variable with maximums of 100° per second in pan mode and 20° per second in tilt while sustaining 90 mph winds. 1 Win MPC Setup When Win MPC (figure 17) is used to set up the iView, it must be isolated from all other iViews in the system