Download Da-Lite Tensioned Large Cosmopolitan Electrol 120" x 160" .PDF
3892184 Downloads
3.61 MB .pdf
Any implied warranties of fitness for use, or merchantability, that may be mandated by statute or rule of law are limited to the one (1) year warranty period. To use multiple switches, an optional low voltage control must be used. Instruction Book for tensioned LARGE CoSMOPOLITAN® Electrol® DA-LITE SCREEN COMPANY LLC 3100 North Detroit Street Post Office Box 137 Warsaw, IN 46581-0137 USA P 800-622-3737 / 574-267-8101 F 877-325-4832 / 574-267-7804 www. The slat retainer screws must be removed before installation. Incorrect stopping position in downward direction. stop screw viewing surface (audience side) FIGURE 2 screen adjustmenT Screen travel is stopped automatically in the down and up positions by the limit switches that are preset at the factory. “Up” Position Check for power across red and white leads. Keep in mind you will need at least 2-3/4" between the ceiling and the top of the wall mount bracket to be able to position the case on the bracket. Power at junction box (d)Thermal overload tripped. 5 THIS PAGE IS INTENTIONALLY LEFT BLANK 6 LIMITED ONE YEAR WARRANTY ON DA-LITE PRESENTATION PRODUCTS Da-Lite Screen Company LLC warrants its products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser provided they are properly operated according to Da-Lite’s instructions and are not damaged due to improper handling or treatment after shipment from the factory. The use of an accessory attachment not recommended by the manufacturer may cause a risk of fire, electric shock, or injury to persons. Therefore, it is advised to wire the switch or provide a 3-conductor connection that is accessible. Installer must route power to the wall switch and to the junction box located on the left end of the screen case. NOTE: This screen can only be controlled by a single 120VAC or 240VAC wall switch. php to find installation and troubleshooting videos and tutorials. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces. GREEN (GROUND) IMPORTANT Note: The wall switch is REQUIRED to make any limit switch adjustments, EVEN if a third party control system is used. Attach the ceiling brackets to the wall mount bracket using the supplied 5/16" x 3/4" bolts, washers and nuts. 1-1/8" case hook ceiling mount bracket 5/16x3/4" bolt, nut and lock washer 2. com e-mail: [email protected] IMPORTANT SAFETY INSTRUCTIONS When using your video equipment, basic safety precautions should always be followed, including the following: 1