30 CU. FT. Trailer Vac

Download 30 CU. FT. Trailer Vac .PDF

4130015 Downloads

8.17 MB .pdf

ANY MACHINE USED FOR RENTAL PURPOSES ARE GUARANTEED FOR 45 DAYS FROM DATE OF ORIGINAL SALE ONLY. Partially thread the bolts into each of the two tabs located on the blower housing. SIDE PANEL (1) K1191 3/8” x 1” HHCS (1) K1180 5/16” NYLOC NUT (1) B0132 BALL CLEVIS (1) J0522 HANDLE GRIP (1) B3492 DUMP HANDLE (1) A0354 PAN ASSEMBLY (1) A0263 TAIL GATE ASSEMBLY (1) A0312 HITCH PIN ASSEMBLY (1) J0310 LATCH SPRING (1) A0837 ENGINE MOUNT ARM ASSEMBLY (1) B0574 PAN SUPPORT A0121 SMALL UNIVERSAL BOOT KIT A0849 BOOT KIT PEC O HARDWARE BAG A0137 LARGE UNIVERSAL BOOT KIT PEC A0856 BOOT KIT O HARDWARE BAG (2) H5001 RUBBER TIRE 9 (1) A1100 CHASSIS ASSEMBLY PEC O (1) A08155 UNIT ASSY. The container will swing upward and the container will rotate downward. Keep your eyes and mind on your unit while mowing or operating your attachment. Secure the trailer to the hitch plate by inserting the hitch pin assembly P#(A0312) into the hole on the engine mount pivot pin as shown in Figure 2-6. Once the container is full of clippings, the operator can easily remove the trailer door, unlock and raise the lift handle and the container will pivot towards the ground. DO NOT sharpen blades while still attached to the mower. Always remove the ignition key before beginning maintenance. Insert the adjusting rod into the mounting hole on the engine mount arm assembly as shown in Figure 2-6. Slide the other end of the lower hose over the boot and tighten the hose clamp. This manual is provided to give you the necessary instructions to properly mount and operate the collection system on your mower. Correct any deficiency before continuing operation. Slide the curved end of the dump handle through the slot in the handle brace. Secure the hood to the trailer using the four rubber straps shown in Figure 2-5a. Freight and mailing will be borne by the customer. The cost of normal maintenance and normal replacement of service items such as belts, cutting blades, hoses, etc. Secure with blades to the shaft with (2) 1/2”-13 x 1-1/2” HHCS P#(K1233), (2) 1/2”-13 hex nut P#(K1243), and (2) ½”internal tooth lock washers P#(K0057). Unit Model Number:_ Unit Engine Size: Unit Serial Number: _ Date of purchase: _/_/_ Dealer/Distributor Name: _ Dealer’s/Distributor’s: _ State:_ Zip: Phone Number: Address: PECO Inc. nor any company affiliated with it makes any warranties, representations or promises as to the quality of performance of its products other than those set forth herein