Download Model 801 and 802 Ma.. .PDF
5505933 Downloads
2.64 MB .pdf
Correction done! 68 S h e n z h e n L i n s n Te c h n o l o g y & D e v e l o p m e n t C o . Load partition: usually for full (led display) correction mode; load saved correction info to whole led display. 54 S h e n z h e n L i n s n Te c h n o l o g y & D e v e l o p m e n t C o . 1 Click Screen area color correction, select Photo partition. Use monitor for card/box: when enable, go to Option menu, Led Screen Monitor, will have Card/box monitor window, to read each receiving card firmware code and temperature and so on; Use monitor for dot: reserved for future development; Single color only: black and white color; Enable ExCard Bright: enable function board automatically brightness adjustment function; Remember LAN: only for non-sending card control mode; Video card Frequency:: working frequency of current graphic card; Port of hot backup: Select a port for backup data. Hardware requirements: Camera: Canon 5D Mark II, Canon 50D, Canon 500D, Canon7D Lens (50-500mm for outdoor, 70-200mm for indoor) 1/64 Neutral Density Filter (not a must) Ptz (like Manfrotto 410) Tripod (like Manfrotto 055DB) Linsn 8th generation control system 2. , L t d Tick Enable dot-correct for soft in Sender tag, Save on sender 2. Double 24bits and 64KHZ hi-fi digital analogy and modulus switch to transmit the voice, making display achieve the perfect video effect. 16bit(16384),32bit(32768),64bit Screen power: to turn on/off enable LedStudio to control on/off Screen power off: turn off sending card signal for output Asyn mode: Not yet available Hardware: show sending card info by clicking Check Hardware Other: leave it empty. Open LedStudio, “Option”-“software setup”-key in “linsn”-password “168” show as following: 70 S h e n z h e n L i n s n Te c h n o l o g y & D e v e l o p m e n t C o . : name the cabinets Level: leave as default value Modulus: leave as default value 66 S h e n z h e n L i n s n Te c h n o l o g y & D e v e l o p m e n t C o . Use 10 bit colors: when 10 digit signal input is applied to TTL; Use plug and play for DVI: automatically enable DVI port of graphic card; Enable dot-correct for soft: enable dot correction effects; Enable dot-correct for hardware: reserved for future development. Extension cable: this is used when Splitter (hardware) applied. Note: in Screen Area, Start X, Start Y cannot be set beyond the RJ45 U port resolution; otherwise the led screen would freeze or appear wrong codec. , L t d 50-pin outputs 36 S h e n z h e n L i n s n Te c h n o l o g y & D e v e l o p m e n t C o . Our experienced technician favorite is within160*128. Users can adapt two computers to control a display at the same time, when one is out of order, the other will replace it automatically; Users can also use one computer with double network cables to control a display, when one is out of order, the other will take place of it automatically, making the display work normally all time. If hub card is Linsn Hub Card, it has pin assignment in each pin. The intelligent supervision function In each receiving card, there is a temperature sensor and four fan-power-output-ports. It needs to work with our video processors using the 30 bits TTL