Download GLBM188HB Serial .PDF
2692367 Downloads
3.97 MB .pdf
In addition, the synchronizing signal is available in order to compose a basic standard time in the clock circuit. In this service manual, the touch control panel assembly is divided into three units, Control Unit (Display unit), Key Unit and Power Unit, and troubleshooting by unit replacement is described according to the symptoms indicated. 1) Disconnect the power supply cord, and then remove outer case. Door latch heads smoothly catch latch hook through latch holes and that latch head goes through center of latch hole. [3] REMOVAL OF OVEN FROM WALL (Two persons recommended to remove the oven) 1. Removal of the outer wrap gives access to voltage above 250V. 17)Reconnect the power supply cord after the outer case is installed. NOTE: NOTE: If the door sensing switch contacts fail in the open position and the door is closed, the cooling fan motor, stirrer motor and oven light will be activated by RY1. Microwave power operation is as follows: When oven is plugged in, 120 volts A. Reconnect the leads to the primary of the power transformer. When the door is opened, the monitor switch contact close (to the ON condition) due to their being normally closed. Therefore, before checking the performance of the touch control panel, 3) Others: Hand tools 1) Disconnect the power supply cord and then remove outer case. DISCHARGE THE HIGHVOLTAGE CAPACITOR BEFORE SERVICING. Disconnect the high voltage wire leads of the high voltage rectifier assembly from the magnetron. Set the cooking control on Full Power Cooking Mode. 4) Disconnect the sensor connector that is mounted to control panel. It is designed to prevent damage to the oven unit if the food in the oven catches fire due to overheating produced by improper setting of cooking time or failure of control unit. 3) Re-connect the leads to the primary of the power transformer. When the door is opened, the switches interrupt the circuit to all components. Disconnect the connector CN-G from the switch unit