Download USER`S MANUAL .PDF
8120635 Downloads
4.31 MB .pdf
0 Special configuration tool Status monitor Browser Interface Module Configuration Special configuration tool management Browser Firmware update TFTP Communication ARP, RARP, IP, ICMP, TCP, UDP protocols Communication mode Port 9100, LPR/LPD for print Software packages (include DLL and Demo), Printer Status inquiry browser Average print speed Over 50KByte/s Table 2. 2 Printer status page - 30 - JK-W01 USER MANUAL Click “TCP/IP” to enter IP parameter configuring page. 0 Trademarks SNBC registered trademarks: Marks means Warning: Items shall be strictly followed to avoid injury or damage to body and devices. 1 Interface status page When clicking “Printer Status”, you can check the printer status page connecting with JK-E01 module. 1 Self-test page information -6- JK-W01 USER MANUAL Note: ¾ Interface Type: the type of WLAN interface fixed as Wi-Fi; ¾ SSID: shows service zone marks of wireless communication; ¾ Mode: wireless mode, include Infra(Infrastructure)and Ad-Hoc mode; ¾ Interface Firmware: shows the firmware version of interface module ¾ IP Address: shows the currently used IP Address of interface module. The self-test information relative to WLAN Interface is as below: Figure 5. 1 - 18 - JK-W01 USER MANUAL DHCP: Disabled Without security settings Print test page Select the printer in list box and click the button “Print Test Page” in main window, then you could print out test pages with printer, of which include the parameters of JK-W01 module. 2 PORT properties column - 21 - JK-W01 USER MANUAL 3) Select “Standard TCP/IP Port” in the list box of “Printer Ports” and click “New Port” Button as shown in Figure 5. 264209 Hot line: +86-631-5673777 Fax: +86-631-5673778 E-mail: [email protected] -2- JK-W01 USER MANUAL General Safety Instruction Before installing and using the printer, please read the following items carefully: 1) Please comply to the cautions in Printer User’s Manual, as this interface module belongs to a part of printer; 1) Do not put USB device not confirmed by SNBC into USB interface of JK-W01 module; 2) Keep this manual carefully in hand for use and reference. 8, then “confirm”, and TCP/IP Port configuration is finished. Caution: Items with important information and prompts for operating the printer. This page shall provide two configuration modes: 1. Or any TFTP customer tool can transmit the firmware-upgrading document to 69 - 25 - JK-W01 USER MANUAL Port of JK-W01 module for updating. 1 JK-W01 installation -5- JK-W01 USER MANUAL 5 Usage of JK-W01 Module When use the interface module, user needs to know the parameters of the interface module, like the IP address, SSID, the communication pattern, the channel and so on to set the module. 5 wireless security information configuration - 32 - JK-W01 USER MANUAL 5. Click “Printer Status” button to enter Status Monitor Window (shown as Figure 5. jk Among which –i presents to transmit documents in binary mode; 192. Otherwise a failure prompt shall mention an error: Recover default settings Select the device in list box and click the button “Restore Default Configuration” in main window, and then the printer could recover the default settings as below: SSID: default SSID Mode: Ad-Hoc IP: 192. If TCP/IP port isn’t installed, click “Add port” button; - 20 - JK-W01 USER MANUAL Figure 5. 100m without any block (it changes with operation environment) 16±2dBm(802