Download Strong™ Contractor Series Universal Articulating Mount for .PDF
3421596 Downloads
8.26 MB .pdf
NOTE: This mount supports display mounting from VESA 75x75, 100x100, 200x100, 200x200, up to 600x400. NOTE: A properly mounted Arm Assembly will be oriented so that its Keyed Notches side of the Arm Assembly Head Mount is upward. (R) Display Bracket Assembly (A – M) M6 or M8 Washer Hole Bolts (A – M) (size depends on display) M4 or M5 Washer Hole Washer (R) Display Back Figure 4 Attach Screen to Arm Assembly Small Displays (Up to VESA 200x200) and Large Displays (Up to VESA 600x400) ATTENTION: This procedure requires two persons to perform. Lift the display and hook the two bolts (Y) in grooves on top of the Mounting Head. The wall or mounting surface must be capable of supporting the combined weight of the mount and the display; otherwise the structure must be reinforced. The Adapter Plate should be horizontally centered on the back of the display. Loosen Tilt Levers on each side of Head Mount (only enough to allow controlled adjustment) (Figure 8). Place the pads on the opposite side from the Cable Covers where possible impact points will occur (Figure 7). Proceed to the mounting section for instructions on how to mount the bracket to the display. Leave approximately 1/4" of exposed thread (do not fully tighten). Drill holes in marked locations: • Use 1/4" bit for drilling into wooden studs. Leave approximately 1/4" of exposed thread (do not fully tighten). Follow all instructions and recommendations regarding suitable locations for display installation. Use a stud finder to find the nearest wall stud if applicable and mark their location. Then, slide the other Adapter Bracket in or out until it aligns with the second set of mounting holes. Ensure that the arm is set to its maximum negative tilt prior to attaching the display. A minimum of two people is required for this installation and it is highly recommended that this product be installed by qualified professionals. Attach the assembled Adapter Plate to the display using the screws (A – M). Then firmly hold opposite corners of the display and gently turn it into the desired position. ATTENTION: Before drilling, verify there is a minimum of 1-3/8" of concrete thickness to be used for the concrete anchors