Download WHS-002 Instructions .PDF
4691896 Downloads
3.40 MB .pdf
To install the Wheelspacer Kit, follow these steps: 1) Remove tire as per Jeep Service Manual procedure. 3) Re-assemble tire to Wheelspacer using existing lugnuts. Tighten lugnuts in a criss-cross pattern to 85-110 ft-lb [115-149 N-M]. Tighten lugnuts in a criss-cross pattern to 85-110 ft-lb [115-149 N-M]. It is recommended to double check this torque after driving vehicle 50 miles. 2) Apply thread lock to OEM wheel studs using Loctite 271 (LCT-271) and assemble spacer (WHS-103) to drum/rotor face using lugnuts (MLN-5340) provided. Have another person apply brakes to prevent drum/rotor from spinning. This kit comes complete with two aluminum wheelspacers (with five wheel studs pressed in each) & ten lugnuts. 500” of track to either the front or rear axle of the 4. Be sure that OEM studs FULLY CLEAR Wheelspacer so spacer fits flush against drum/rotor face. The Wheelspacer Kit is a bolt on product and installs in a similar fashion as installing a wheel. Orient lugnut (MLN-5340) so tapered surface mates with tapered surface on spacer