Download ioLogik E2240 Series User`s Manual .PDF
6051094 Downloads
2.54 MB .pdf
Message Monitor Tab The Message Monitor tab will display any TCP/UDP I/O messages received from the ioLogik E2240. This is required whenever you start up ioAdmin or boot up/restart the ioLogik E2240. If the Host Connection Watchdog is disabled, the ioLogik E2240 will never enter Safe Status and the Safe Status settings will have no effect. After the ruleset has been downloaded, you must restart the ioLogik E2240. Up to 10 IP destinations for the message can be specified in the Message Receiver list. Network Settings General Settings On the General Settings page, you may assign a server name and location to assist you in differentiating between different I/O servers. After the ioLogik E2240 has restarted, the ruleset must be activated for Active Ethernet I/O operation. If necessary Dynamic fields such as time, date, IP address, and I/O status may be inserted in your message by clicking on the Keyword Lookup button. 3-5 ioLogik E2240 User’s Manual Using ioAdmin Server Settings Tab (General) The Server Settings tab is where you log in as an administrator. Enter this submenu to display the restart now submenu. This will activate the ruleset and the ioLogik E2240 will begin working as an Active Ethernet I/O server. Factory Default Settings The ioLogik E2240 is configured with the following factory defaults: Default IP address: Default Netmask: Default Gateway: Communication watchdog: Modbus TCP alive check Timeout: 192. You may access the wiring guide by right-clicking the graphic of the ioLogik E2240 in the I/O Configuration tab. Select “Wiring Guide” in the submenu to open a help file showing the wiring information and electrical characteristics of the ioLogik E2240. H-2 Problem Report Form H-3 Product Return Procedure H-4 1 Chapter 1. Test I/O: You can test the AO channel in the Test tab, Note that the slider shows both the raw data value and the engineering value (V/mA). Tel: Fax: Web: +886-2-8919-1230 +886-2-8919-1231 www. The default settings are baudrate = 115200, parity check = N, data bits = 8, and stop bit = 1. Under Mail Server Settings, you must configure the IP address of the SMTP server with your username and password. Search the network for the server: On the menu bar, select System Æ Auto Scan Remote I/O Server