RS90 v3

Introduction:

This was the kit I got when I first wanted a RS90. After it arrived, I decided to print and build my own instead from scratch and so this sat in the box for months with the motors and escs pre assembled. I recently decided to finish it off just to see how the original handles.

Components:

• 3d printed frame (top frame is nylon, bottom frame is ??)
• M2 x 10mm nylon standoffs x14
• M2 6mm screws x28
• hubsan tri props
• frsky eachine receiver
• 4x ESCs (DYS XM10A? - not sure)
• 4x DP03 motors
• F3 omnibus flight controller
• 5v voltage regulator
• FPV camera & Furibee VTX03 25/50/200 switchable VTX

Conclusion:

I went with a omnibus FC since I was sure I wanted OSD. I wasn't sure what the ESCs were, but I didn't care about taking off the heat shrink to find out since I knew I only wanted to run it on 2s. However, the rest of it was assembled to be able to handle 3s. The weight would probably have gone down a few more grams had I used a 1g receiver instead, but the 58g weight isn't too bad overall. Not so surprisingly, it handled just like the other RS90s I had with different motors & esc combos. :)