Enelion Stations can be integrated into the eCarUp billing system in just a few steps. Once installed in your account, you can easily define the conditions of use for your stations yourself (prices, users, available times, etc.). You decide who can charge, when and at what price.
Prerequisite for integration via OCPP
Configuration in the web portal for station operators
Learn more about our premium functions here
Make sure that your charging stations are installed and that your computer or cell phone is connected to the same network as the charging station.
Open the eCarUp web portal and log in with your account details.
Click on the "Stations" tab in the menu on the left-hand side.
Select the "OCPP" tab.
Copy the URL to the clipboard.
Go to the web interface of the desired station and paste the copied URL accordingly.
Switch on your Lumina
Use a smartphone for this and go to your WLAN settings
Select the hotspot of the Lumina wallbox (Enelion-xxxx-xxx)
Open your browser on your smartphone and enter the following IP address: 192.168.8.8
The Enelion setup page opens
Enter the required password. You will find the password on the letter supplied by Enelion.
Under Network, the station can be connected to WLAN or GSM.
Select "Authorisation" under Charger
Remove FreeCharge mode and save
Select "Connection" at OCPP
Activate OCPP Connection
Under Connection settings:
Set Device to Master
Connector ID 1
Freecharge idTAg must not be empty. A master badge can be stored here (whitelist) or, if it has no significance, analogous to the Printscreen example.
Enter your eCaRup URL from the account.
Charge Point ID must also not be empty and can be individually labelled. (Attention: max. 20 characters and no spaces)
+ Save and restart.
Check the connection status of the station in the dashboard.
The upload interval of the Meter Values may vary from station to station.
We recommend an interval between 30-60s. This is the only way we can better calculate and display the current charging power on the app.
You can change this as follows:
Get Configuration (to read out what is programmed).
Change Configuration (to overwrite the value)