ELECTRICAL: ROUGH IN – BASIC DESIGN
Embedded Files
EMT is allowed and encouraged. It saves time and effort for the majority of contractors. We expect there to be 2 exposed runs of EMTs in every house, in a place of prominence.
Rules of Thumb for EMT Use
Symmetry: When EMT is going to a single fixture or sconce, in a-symmetrical installation is encouraged. However, if it is going to multiple fixtures, the use of symmetry is encouraged. See pics for examples of what TO DO.
Every house should have at least 2 locations where EMT is used. Generally, this will be in the living room, at the front of the house. Use the switch box by the front door, use a ring extender, and run the EMT to the light in the center of each room. If there is already an existing light fixture there, there is no need to run EMT.
Box Extenders: These can be an easy way to run circuits without cutting drywall. If you need to do minor electrical work, use this method for running the wire.
If running EMT creates more work than it saves, do not run it. Don't do a crazy amount of bends and the like. Most runs of EMT should require no more than (2) 90-degree bends.
Always use “I” style brackets for support of EMT. This allows the paint to be applied behind the EMT and eliminates the need to do an offset bend. Use “Snap Toggles” to support the drywall, rather than a typical plastic drywall anchor. WE PREFER TO MOUNT IT INTO A STUD.
For ceiling boxes, only use boxes that are approved for CEILING FANS. This gives us optionality later in the renovation process. We often prefer boxes that mount on a ceiling rafter.
BOXES: Always use Adjustable Boxes for switches and lights. There are many times that the drywall will not be level, which will make keeping the plates flush easier
These pictures show a sample kitchen layout.
Page updated
Report abuse