Pre-cleaning considers trash removal. You’re likely to fill several trash bags with dust and debris (it’s surprising how it mounts up, even after a small renovation). If your contractors used a dumpster, ask if you can use that, or consider hiring a dumpster bag or speaking with your waste management company about collecting a large amount of trash.
Try to get the area as dust-free as possible before you start cleaning intensively. Not only will this make your final task easier, but it’s also safer to avoid breathing in a lot of dust or debris. Seal off any rooms that aren’t affected using plastic sheeting available from most hardware stores, and use masking tape (also known as painter’s tape) to secure the plastic to your walls and doors without causing lasting damage. Don’t forget to block vents and openings with more plastic sheeting to protect your HVAC system.
For a first pass, use a soft-bristled broom to sweep each room as clean as possible. Even sweep the ceiling and walls to get all the loose debris and brush toward the center of the room. If the dust is terrible, wear a good quality dust mask while you work. Lightly spraying the dust with water can make it easier to sweep.
Pro Tip: A wet/dry vacuum is great for picking up loose dust, or if the dust is terrible, look for sweeping compounds at the local hardware store. These are sawdust-like mixtures used to bind dust and make cleaning a breeze.
After most construction work, fine dust will be your biggest problem. Even when taking all the proper precautions, this dust is almost impossible to contain completely. Unfortunately, it can cause damage if it clogs your HVAC system or gets into electronics.
The best way to clean fine dust is to use a damp microfiber cloth. If you get the dust too wet, it will turn to mud rather than sticking to the fabric, so make sure to wring the cloth out until it’s barely damp. You want to pick up the dust with the fabric, not soak it. You’ll have to repeat this process on every surface, including floors and walls.
Wash the cloth between each pass and change the water you’re using once it turns cloudy. This will prevent reapplying wet dust to areas you think you’ve cleaned. Then let the area dry thoroughly and use a vacuum with a brush attachment to remove any remaining dust. Finally, spot clean with a damp cloth and give the walls and floor a final wipe.
Pro Tip: If you have fine dust on a carpeted floor, rent a wet/dry vacuum from your local hardware store. Getting a vacuum with a HEPA (High-Efficiency Particulate Air) filter will ensure it removes as much dust as possible.
RIGHT WAY OF USING PRESSURE WASHER