This Policy is Under Development

Purpose

The purpose of this procedure is to establish the minimum requirements for performing diagnostics and replacement of the 5 Port Eternet Hub that is installed in Flogistix LOGIX panels on Gas Engine and Electric drive units as laid out in this procedure.

Procedure

This procedure applies to all units that are currently in service in the Field, Test Loop, at a Repair Shop, or in Storage Yards.  Flogistix Service Technicians will perform the diagnostics as required according to the type of 5 port Ethernet Hub being used in the LOGIX panel..

Before any work is performed a JSA needs to be done according to Flogistix procedure along with any Customer requirements before any work is started.

The 5 port Ethernet Hub in the LOGIX panel does not require power from the LOGIX power supply to operate.

When a Ethernet cable coming from a device in the panel is plugged into the Ethernet Hub there should be two lights illuminated where that Ethernet cable was plugged in.  If there is a solid green light on it is meaning there is an Ethernet Port connection.  There will also be an orange light that could be on.  If the orange light is on but is on solid that means the Port is connected, but data is not being transferred.  If the orange light is on but is blinking it means that the Port is connected and Data is being transferred.  

All Ethernet cables plugged into the Ethernet port should have the two lights on with the green light being solid and the orange light blinking.

Responsibilities

Management - Management is responsible for implementing, supporting, and enforcing the requirements of this procedure to their respective locations/area.

EHSS - Responsible to assist in the implementation of this procedure and to review for effectiveness.

Employees, Contractors, Vendors, ETC. - Are responsible to follow the follow the requirements outlined in this procedure and ask for assistance

Scope

This procedure applies to all skids equipped with LOGIX panels that have the 5 port Ethernet hub and are applicable to all Flogistix employees, contractors, and temporary employees.

Hazards

Employees should be aware that units could contain flammable and toxic gasses.  Potential for the possible hazards of gas ignition or fire, hot surfaces & fluids, rotating equipment.  Risk of possible concentration of H2S.  Hazardous gases could be in the units pressure vessels, cooler, or associated piping and risk of inhalation of hazardous gas fumes.  

Safety

All Personal Protective Equipment (PPE) for normal Field Mechanical duties apply for this procedure.  

Four Gas Monitor, which is outlined in the Flogistix EHSS Manual, PPE Section 8, Procedure 8.3 

This procedure applies to all units in service in the field, at a service shop, or in any storage yard.

Insure Flogistix personnel have proper safety certification or site orientation if required by the Flogistix Customer.

Insure Flogistix personnel adhere to all Customers safety practices.

Proper use of required tools 

Training

All employees shall be initially trained on the following topics:

• Employee Personal Protective Equipment (PPE)

• Lock Out Tag Out (LOTO) procedure according to Flogistix policy

• Emergency and First Aid procedures

• Methods and Observations that may be used to detect the presence or release of hazardous chemicals or gas in the work place

Tools & Equipment Required

All employees performing this procedure shall be required to have the listed tools to perform job tasks:

• All required PPE according to Flogistix Safety Policy

• Lock Out Tag Out LOTO items to properly perform LOTO procedure according to Flogistix policy

Approvals

Field Service approved by:

Date:

Engineering approved by:

Date:

EHSS approved by:

Date: