1.04.015 FXQ Gas Lift Ariel Recip Valve part number listing

Responsibilities

Management - Management is responsible for implementing, supporting, and enforcing the requirements of this procedure to their respective locations/area.

EHSS - Responsible to assist in the implementation of this procedure and to review for effectiveness.

Employees, Contractors, Vendors, ETC. - Are responsible to follow the follow the requirements outlined in this procedure and ask for assistance

Scope

This document applies to all FXQ Gas Lift recip compressor units with the above listed cylinder sizes driven with either a Gas engine or electric motor and is applicable to all Flogistix employees, contractors, and temporary employees.

Hazards

Employees should be aware that installing the incorrect suction or discharge valve into a compressor cylinder and put into service can result in the potential catastrophic failure of the compressor cylinder with the potential for injury or death.

Installing valves with the incorrect valve lift could have the potential to increase interstage pressures and cause overpressure of compressor cylinders.

Employees should be aware that units could contain flammable and toxic gasses. Potential for the possible hazards of gas ignition or fire, hot surfaces & fluids, rotating equipment. Risk of possible concentration of H2S. Hazardous gases could be in the units pressure vessels, cooler, or associated piping and risk of inhalation of hazardous gas fumes. Environmental spill of compressor oil and possible production fluids

Safety

All Personal Protective Equipment (PPE) for normal Field Mechanical duties apply for this procedure. Four Gas Monitor, which is outlined in the Flogistix EHSS Manual, PPE Section 8, Procedure 8.3 This procedure applies to all units in service in the field, at a service shop, or in any storage yard.

Insure Flogistix personnel have proper safety certification as required by the Flogistix Customer.

Insure Flogistix personnel adhere to all Customers safety practices.

Proper use of required tools

Training

All employees shall be initially trained on the following topics:

• Employee Personal Protective Equipment (PPE)

• MSDS Online System

• Emergency and First Aid procedures

• Methods and Observations that may be used to detect the presence or release of a hazardous chemicals or gas in the work place

Tools & Equipment Required

All employees performing the disassembly, assembly of compressor valves, replacement of compressor valves shall be required to have the listed tools to perform job tasks:

• All required PPE according to Flogistix Safety Policy

• Assorted end wrenches up to 3/4"

• 3/8" Torque wrench

• 12 point socket set (for Valve cap bolts)

• Screw Driver set

• Small Pry Bar

• Ariel Valve installation tools (recommended but not required)

Approvals

Field Service approved by:

Date:

Engineering approved by:

Date:

EHSS approved by:

Date: