7.07.001 Updating IP Address (Guide)

This Policy is Under Development. If questions please contact Shawn Radcliff or Mark Metzger.

Purpose

The purpose of this trouble-shooting guide is to assist you in Updating the IP Address when changing the Modem in a LOGIX Panel.

Procedure

This procedure applies to all units that are currently in service in the field, at a repair shop, and in storage yards.

Before any work is performed a JSA must be completed according to Flogistix procedure along with any customer requirements before any work is started.

Responsibilities

Management - Management is responsible for implementing, supporting, and enforcing the requirements of this procedure to their respective locations/area.

EHSS - Responsible to assist in the implementation of this procedure and to review for effectiveness.

Employees, Contractors, Vendors, ETC. - Are responsible to follow the following requirements outlined in this procedure and ask for assistance

Scope

Hazards

Employees should be aware that units could contain flammable and toxic gasses. Potential for the possible hazards of gas ignition or fire, hot surfaces & fluids, rotating equipment. Risk of possible concentration of H2S. Hazardous gases could be in the units pressure vessels, cooler, or associated piping and risk of inhalation of hazardous gas fumes. Environmental spill of compressor oil and possible production fluids

Safety

All Personal Protective Equipment (PPE) for normal Field Mechanical duties apply for this procedure. Four Gas Monitor, which is outlined in the Flogistix EHSS Manual, PPE Section 8, Procedure 8.3 This procedure applies to all units in service in the field, at a service shop, or in any storage yard.

Insure Flogistix personnel have proper safety certification as required by the Flogistix Customer.

Insure Flogistix personnel adhere to all Customers safety practices.

Proper use of required tools

Training

All employees shall be initially trained on the following topics:

Employee Personal Protective Equipment (PPE)
Lock Out Tag Out (LOTO) procedure according to Flogistix policy
MSDS Online System
Emergency and First Aid procedures
Methods and Observations that may be used to detect the presence or release of a hazardous chemicals or gas in the work place

Tools & Equipment Required

All employees performing Preventative Maintenance shall be required to have the listed tools to perform job tasks:

All required PPE according to Flogistix Safety Policy
Lock Out Tag Out LOTO items to properly perform LOTO procedure according to Flogistix policy
Basic Hand Tools

Approvals

Field Service approved by:

Date:

Engineering approved by:

Date:

EHSS approved by:

Date: