Yes sure we can fix your Heels on your ... Boots, Shoes, Sandals ...ANY Footwear!
Main Steps
1 Remove old heel piece
2 Grind Heel Block Flat
3 Check Angle
4 Check Heights
Remove heel starting from inside front corner of shoe. More
Grind right heel flat
Max 5mm gap under 1/2 sole.
Check heel heights match, now grind the left to match.
5 Do Builds
Grind build area so edges are square and crisp. Atom build onto block. Knife off excess and machine trim sides,then bottom. More
6 Glue Shoe then new Heels
7 Heels in Oven, Shoes not
8 Push together, Nail, Hammer
9 Knife, Heel Trim, Cone, Deburr
Select precut heel,Quick choice, bigger is fine, make sure right colour,
10 Polish Till Pretty
Want heels soft enough to trim.
CHECK glue line is sealed and consistent.
1 Carefully remove old heel piece
2 Grind and check height and angle, do builds if needed, use atom
3 Cut new Vulcotop heels.
4 Glue shoes and then heels with 1222
5 Heat up, assemble then nail
6 Trim heels
7 Polish, inspect and put out front.
Getting heel blocks ground even – if they are badly worn down do builds
1. start with the lowest one, measure the back corners and get them equal,
2. measure the front corners and get them equal,
3. level off the middle.
Now copy the measurements over to the other heel block and repeat. Draw any pen marks in such a
way that they get ground off.