MX Soles

Yes sure we can glue a new set of soles onto your MX Boots, we use the SIDI Soles as they last really well where many others get chewed out by the foot pegs, we can also glue your exiting soles back on if they are still in good condition.

Gluing SIDI, Gaerne, Alpine Star, Fox

1. TPR Primer onto Sole and Boot (as long as boot or sole is not porous!)

2. Clear glue then wait at least 2hrs

3. Clear glue then wait at least 30min

4. Assemble as per manual

IF the boot or sole is porous DO NOT USE PRIMER you can still rub it with solvent and let dry before gluing if you think it needs it.

FOX Instinct inserts

1. Remove insoles so hammering can work better
2. Grind insert and boots. If insert is pre glued remove all of the glue
3. Test fit insert and trim top edges if they are going to sit up and make a lip
4. 2 coats of clear on boot and insert
5. To assemble, Boot on last and heat with heat gun, insert in oven. Heat both to 70 degrees, test with temp gauge.
6. Hold edges out and assemble back then front then edges.
7. Knock solidly with hammer on sole and then around edges and up sides
8. Press at 2? bar so that edges don't get pushed up over lip

If the insert goes green with first layer of clear glue, regrind and coat insert with atom then 2 coats of clear glue.

This document is confidential and proprietary to Cobblix and cannot be used, disclosed or duplicated without the prior written consent of Cobblix. This is an unpublished work protected by copyright laws and no unauthorized copying, adaption, distribution or display is permitted.