Punch Holes to 4mm
Test cap for fit
Only the second layer, not the first layer. So that the rivet cap can fit easily. But tight fit on first layer so cap stays put while you get it all lined up.
Adding glue to caps
Yes the cap will be coming from the other side. Note the masking tape to hold cap in place inside the boot while the glue is added and the Decoration pushed into place, ready for knock with hammer.
Using "Blank" to knock deco with hammer
Caps are inside the boot in between lining and upper, held in place with masking tape.
Boot has been slipped onto last. So caps are sitting flat on last for good support