Embedded Files
In the event that the SD card becomes corrupted, the comma-healthcare recovery image installed on the internal flash memory can be used to reinstall Wanderbox software on either the same SD card, or a new SD card provided by Far South Networks.
In order to install the Wanderbox software on to an SD card in your Wanderbox, follow the steps described below:
- Shutdown Wanderbox by holding in the power button on front of Wanderbox until it switches off.
- Remove the SD card from Micro SD slot on Wanderbox.(See Removing and adding an SD card into Wanderbox)
- Power on the Wanderbox, by pressing the power button.
- SSH into the Wanderbox.(See How to SSH into a Wanderbox or Com.X)
- Run Comma-Healthcare from the Command line, by typing: sudo comma-healthcare
- Once Comma-Healthcare has initialized the below page will appear:
- Select Continue.
- Select Wanderbox PBX and Gateway 1.4
- Select Update local repository ( Ensure the Wanderbox is on the internet and able to communicate with our repository (update.commanet.co.za), to pull packages.
- Select Continue with local package versions
- Select Exit
- Insert the SD card into the Micro SD slot on Wanderbox. (See Removing and adding an SD card into Wanderbox)
- Run Comma-Healthcare from the Command line, by typing: sudo comma-healthcare
- Select Continue
- Select Wanderbox PBX and Gateway 1.4
- Select Continue with local package versions
- Select the SD card that was inserted as the media device to be used for installation.( In below screenshot a 32G SD card was inserted)
- Select On Internal Flash as the configuration.
- Select Install factory default on SD as the option
- Select OK, to confirm install system on /dev/mmcblk0
- Once Installation is complete, Select OK, to reboot system.
- The Wanderbox will then reboot.
- Once Wanderbox has rebooted, SSH into the Wanderbox.(See How to SSH into a Wanderbox or Com.X)
- Run Comma-Healthcare from the Command line, by typing: sudo comma-healthcare
- Select Continue
- Select Complete Installation
- Once Installation is complete, Select OK, to reboot system.
- Once Com.X has rebooted, log into the Comma GUI.(See How to log into the Comma GUI of your Wanderbox or Com.X)
- Once logged into the Comma GUI, you will see that the Serial number is unknown and the License will be highlighted in red, this means that the Comma GUI needs to be license again.
- Add the Comma GUI license to the Wanderbox. (See How to License a Wanderbox or Com.X)
The Wanderbox is now fully operational and ready to be implemented again. Please note that if you make use of the Comma Operator Panel and Comma Fop2, you would need to install these packages manually from the Comma-GUI.
Google Sites
Report abuse