01 Cloris Bo

The initial sketch

Work in progress

Final product

Steps

Sketch out your design on a piece of paper
Plan out where you want to cut/not cut (you can change design later on if you want)
Draw your design on the lino block
Cut the ruuber according to your design
Ensure you cut deep enough into the rubber
Print

FInd a picture for the piece, outline and fill in the shadows, add some designs if you want

Do the same process on the other side of the paper by putting the paper under bright light, use either a marker or a 4B/6B pencil

Write down your colour scheme at the bottom and what colour to cut first

By using the reversed side, place a carbon paper between the lino bock and the paper and outline using a ballpoint pen

quite a long process as you may have to re outline with the ballpoint pen a few times so that it can be traansferred onto the inoblock

First colour print

Cut and print according to colour scheme, try to print 3-5 copies for the first colour

Can do test print to check with there are parts that are uneven and needed to be cut

I printed three copies, all of them were patchy, so I had to print and repeat the process a few times

Page updated

Report abuse