B19: Light SensorÂ
B19: Light SensorÂ
Embedded Files
NOTE: Sensor refers to a probe. Not to be confused the Wi-Fi Sensor (See General Information and Requirements)Â
The light sensor* Wi-Fi node integrates with the temperature/humidity probe. It will detect the presence of light and report it to the cloud.Â
Sensor Number: B19
Contents
Configure
Configure
The light sensor node must always be connected to an external power supply.Â
In the Set Primary Alarm Limit section (the image below), input the details as required. The Default Alarm states can be changed from Dark to Light as the application permits.Â
Light Configuration
Light Sensor Multiple Alarm ScheduleÂ
Light Sensor Multiple Alarm ScheduleÂ
In most cases, the light sensor doesn’t have one alarm state (light or dark). Instead, there are times when the room should by lit and other times when the room should be dark. These alarm settings can be scheduled. To schedule the alarm settings, select Light sensor Check box. Keep in mind that multiple nodes can be configured at one time as is seen in the figure below.Â
Alarm Schedule for light SensorÂ
In scheduling the alarm, the user can set the alarm for different status of the node on different time intervals on the same day.Â
Alarm Schedule for light SensorÂ
Light Sensor ReportsÂ
Light Sensor ReportsÂ
Some of the reports that are available for the light sensor are shown below:Â
Graph Report for Light Sensor
Daily Report for Light Sensor
Page updated
Report abuse