PETROL TANK

Thanks to R3W forum member Clive for pointing me in the right direction for this link

PETROL TANK ; ACCESS ;

How and where to cut access panel in the boot to get to fuel sender/pipe

Following is an extract from an old R3W post which was originally posted by R3W forum member " johno ";

xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx

You may find that the sender unit is at fault in the tank.

Sometimes, if your lucky, the connections will just need cleaning up.

The float could be stuck or the coil of wire in the sender may have snapped (would need replacing if this is the case.

To access the sender the tank needs to be lowered, or you can cut a small hole in the boot floor then make a panel out of some thick plastic to cover up when finished.

This is the access plate I made for my old Rialto, the piccy should give you some idea where to cut.

here's the measurements