Glenn's Retro Show Arcade Spinner for Arcade 1up
TS-USP02
https://www.amazon.com/dp/B07P5WJ7BC?ref=exp_glenplanamento_dp_vv_d
Hole needs to be 35mm confirmed.
Add metal spacer if using Plastic overlay to raise it up a litter.
12 in 1 control board is necessary to work with RPI.
plug the spinner into the 12in1 board port 1 (of three) using the cable supplied with the spinner
DIP Switches
Switch 1 and 2 combined determine Pulse/Per Rotation
1-OFF 2-OFF =16
1- ON 2-OFF =64
1-OFF 2- ON =512
1- ON 2- ON =1024
Switch 3 ON 0.5ms Faster
Switch 3 OFF 8ms (Arcade 1up default setup)
I think all switches are OFF by default.
Pulse per Rotation depends on Game
http://wiki.arcadecontrols.com/index.php/Spinner_Turn_Count
Tempest is showing 72 for Pulse Rotation and it says 1 Full Turn Moves 5 Spaces, but I also think resolution impacts this as well.
If I understand correctly 1024 is most sensitive and 16 is least sensitive. Also from what I can tell most other spinners have over 1000 here so I think we should just set to 1024. Really not of the value of going lower, unless it was for Arcade 1up stock. I need the most flexibility from software, since I don't want to be changing this again.