Pin 05 GPIO03 Black Wire
Pin 06 GND White Wire
Pin 09 GND Gray Wire
Pin 11 GPIO17 Purple Wire
Pin 13 GPIO27 Blue Wire
Make sure in pics above you see it starting with Pin1.
Test before taping
Use python script gpiotest.py to test first.
Running
sudo systemctl status pygpio.service
Showed service was not running so had to re-run service install steps to get it to run.
I reverse wired shaders so swap funcSetShader calls in gpiosvc.py
Note: I had to move down these connections by 1 pin. Since The pic was zoomed. Here they are connected to Pin 3,4 instead of 5,6