Vibration Interface Plate

NOTE: All dimensions are in inches unless stated otherwise.

Magellan Vibration Table Mounting Pattern

The following pattern is used to mount the vibration interface plate to Magellan's vibration table. These are loose-fit through holes. Depending on the mass and volume of the assembly being vibration tested, not all through-holes will need to be used. Exercise caution and be careful when determining which mounting locations to use.

Payload Sample Plate Mounting Locations

The following 8-32 threaded hole patterns are to mount the IRIS EM Sample Plate Assembly.

Note: Only 4 mounting holes are used at once.

UMSATS P-POD Deployer Mounting Locations

The following 1/4-20 threaded hole patterns are to mount the UMSATS P-POD Deployer. There are two copies of the pattern, rotated 90 degrees with respect to each other, to allow the P-POD to be tested in both X and Y axis without removing the entire interface plate.

Note: The keyserts for this pattern have not yet been installed.

UMSATS Half Shell Mounting Locations

The following 6-32 threaded hole patterns and slots are to mount two UMSATS half shell modules. There are two copies of the pattern, to allow two half shells to be tested at once. The slots allow male half shells to be placed flush to the interface plate.

Note: The keyserts for this pattern have not yet been installed.

UMSATS Full Shell Mounting Locations

The following 10-32 threaded hole patterns and slots are to mount two UMSATS shell modules. There are two copies of the pattern, to allow two shells to be tested at once.

Note: The keyserts for this pattern have not yet been installed.