iPhone Holder
Post date: Oct 26, 2017 4:53:09 PM
The first step I took was I designed the part that holds the phone(iPhone 6s Plus in OtterBox case). I wanted it to be slim and have a hole at the bottom so you can plug in headphones and power cord. After finishing that and cutting it out, I measured and designed the supports that would it up at an angle. After seeing the final product I wasn't satisfied, so I redesigned most of the holder. I made the walls taller to just to look better and I think it is more practical. Then I halved the size of the supported and cut the top of them to an angle that is ~45 degrees. This gives the holder a more slim design which I think makes it look good.
first model body
front support
back support
first model
second model
second model with phone and power cord
My base and side walls
Both of my designs for the bottom
The second leg design with the angles