Embedded Files
Required Tools and Supplies
Required Tools and Supplies
Accessory Bag (Tesla P/N 1857363-00-x)
(6) M6 fasteners for front cover (Tesla P/N 1847553-00-A)
(6) MPPT jumpers
(2) cable tie mounts with (2) cable ties for grouping conductors
(1) small clamp-on ferrite core for low voltage harness
Powerwall 3 P/N 1707000-00-H and lower: (2) large clamp-on ferrite cores with (2) cable ties for the AC and PV conductors
Powerwall 3 P/N 1707000-00-J and higher: (1) metal PV shield
Required Tools
Dolly
MC cable cutter
(Required when using PVC-MC cable)
¾" (19 mm) socket
Up to 3/32” (3 mm) electronics tip screwdriver
Up to 3/16” (4.5 mm) electronics tip screwdriver
Torx T20 bit
Required Supplies
(1X) if floor-mounting using single fastener
(4X) if using wall bracket
Metal conduit only
Pre-made Ethernet cables
Minimum NEMA 4 (IPX5) conduit hubs
Figure 1: Dolly
Figure 2: MC cable cutter
**Note**
Minimum NEMA 4 (IPX5) fittings are required when installing outdoors. When Powerwall 3 is installed indoors and there is no risk of water ingress, indoor-rated fittings can be used.
Figure 1. RMC Myers Hub
Figure 2. Bridgeport Connector
Table 1. Approved Conduit Hubs
Approved Conduit Minimum NEMA 4 (IPX5) Fittings
PVC-MC Cable ¾” PVC-MC Connector
1” PVC-MC Connector
EMT ¾” Bridgeport 251-RT2 Connector
1” Bridgeport 252-RTI2 Connector
RMC ¾” RMC Myers Hub with RMC conduit
1” RMC Myers Hub with RMC conduit
¾” RMC Sealing Locknut with RMC conduit
1” RMC Sealing Locknut with RMC conduit
1-¼” RMC Sealing Locknut with RMC conduit
Figure 1. RMC Myers Hub
Figure 2. Bridgeport Connector
Tesla Remote energy kit.
Kit Number: 2045796-xx-y
Model Number: 2002069-xx-y
200 A CT Part Number: 2033376-xx-y
Page updated
Report abuse