Cricut Transfer Tape is generally designed to make transferring vinyl designs on your project surface a cinch. The transfer tap is non-gridded and clear and is placed in the roll without backing. In this blog, you will learn the hacks for using the transfer tape, instructions to get the best results, and solutions if your transfer tape is not working.
This blog section will give you a few mind-blowing hacks you need to know before using the transfer tape. All these hacks are simple and easy to apply. We promise you will fall in love with all the given hacks in this section.
Here are the most useful hacks or tips that you have to know before start using the Cricut Transfer Tape:
My favorite tip is to learn to cut the slits into a simple transfer tape. During applying the vinyl onto a curved surface such as a cup or mug, you can find the transfer tape lays flat and doesn’t want to adhere. Because of that, you are easily able to apply the vinyl down to your surface.
In this hack, we’re utilizing the powder of dollar store baby, and we’re starting to lightly take a few and sprinkle them on the cut vinyl. And then brush it out. The powder is mixed all over the place, making it a darker-colored design, which is amazing.
The third hack is reverse weeding. It is really very easy and easy to do. You only need to take a piece of Cricut transfer tape and stick it to your vinyl piece. You are going to put it into your project without doing any weeding first.
In this hack, when you are using a mat during your work, it may require cleaning. A most valuable tip for you is to use a few masking tapes. We’re trying to put it on here to hold down the vinyl. That’s why we are able to cut easily.
In the last tip, you have to clean your fine point blades. You just have to cut a few pieces of aluminum foils once a month to keep the blade clean and nice. You need to take some aluminum foil and locate it onto the mat; after that, cut it so you can clean the blade.
There are some important instructions that you have to follow to apply the Cricut transfer tape. Here are the instructions:
You need to peel the liner from Cricut Transfer tape.
Add a few areas of Transfer Tape to the design. This can either be on one end of the design or the center.
Take a scraper to make burnish on the Transfer Tape onto the design, doing outward from where you added the small field.
Move the vinyl over and make them shine from the back side.
You need to ensure that the surface is dry and clean. Try to utilize the alcohol to clean the glass and plastic surface simply.
Move out the vinyl liner from the Transfer Tape and also from the design.
Now, add the bit length of your design onto the surface. This field may be the center or any end of the design.
Take a scraper to burnish the design onto the area, and work outward from where you added a small surface.
Now take out the Transfer Tape from your design.
Here are the simple steps that you have to follow to start using the Cricut Transfer Tape:
First of all, you have to cut the transfer tape a little larger than required for your design. You can also use this a few more times this transfer tap; that’s why you do not have to worry about that.
Now, you need to peel back to the paper. Keep in mind that to keep the paperback so you can place the transfer tape back on it for utilizing it later.
Next, put the paper on the design; you need to burn it down well. You can use an old gift card or a scraper.
Now, turn my piece over and move out the backing paper, but you can slide the transfer tape if needed. If your design is not clearly made, then push down and go over with the scraper.
And then, the design on the transfer tape, you can take it and place it on the project.
Now, carefully press the vinyl down and once again start burnishing the design.
Then move out the transfer tape from the design. Make sure that the vinyl is properly stuck in the project area.
Visit: Cricut.com/setup
Source: https://set-cricutting.com/3-important-things-to-know-before-using-cricut-transfer-tape/