For Asset store information, go the Asset Store website
For kit booking requests, please go to the SISO website
There are two kit bags you need to collect from the asset store:
Track bag
Dolly bag (this bag is very heavy!)
Unscrew spreaders on base & move round to where the white arrows are marked
Use the red (or black) tape markers on the extenders as a guide to where they fit into the spreaders
The extenders with curves should be attached to the two spreaders next to the white arrows - with the curves facing in towards one another and the black fittings for the tripod facing upwards
Open up track. Line up black poles so that they are overlapping. It helps to press against your body (be careful with this )
There should be a small black bag of additional parts:
6 x white plugs to fit track together
12 x support blocks go under joining parts of track
4 stoppers for end of track to prevent damage and stop the dolly from rolling off and 3 velcro straps to hold the track in place
It is easier with 2 or 3 people helping. Hold the dolly just above the track, slide the wheel sections up into the dolly, then lower the dolly onto the track, one side at a time
Remove feet or spreader from tripod first & attach to base of dolly.
This operation is much easier with a tripod that has a plastic floor spreader. If your tripod has an internal metal spreader, do not remove, adjust its length by rotating the plastic fittings on its length to loosen and tighten
The seat and supports live in the zip up pocket of the lid of the dolly case
Screw the two seat stand parts together
Screw the seat stand above one of the wheels
This will be facing the direction of travel if you are pushing in
Place the seat on top
Screw silver pin into base plate of the dolly
Screw together the handle
Hook over the pin on the base of the dolly
Ready to Use.............!
(don't forget to add a camera!)
Arrange the wheels in the left hand of the case and the extenders in the foam inlays
Lay the flap over making sure the wheels are in the holes
Insert the large foam inlay and place in the push bars
Insert the the folded up dolly into the foam insert over the bars
Put the seat, the supports and the push handle pin into the zip pocket in the lid of the dolly bag
Lay the first piece of track upwards, then the next piece downwards so they are side by side
Repeat this arrangement for the last two pieces of track. Then secure with the straps attached to the inside of the bag
Return the track blocks, pins, end stops and velcro straps to the small bag
Return the small fitting bag to the zip pocket in the lid of the track bag
Written by LA