Introduction:
Install and run MKS4000b device on new computer.
Important Notes:
Operation Notes:
1. If the device is power cycled, manually turn on the valves and give a setpoint. After that press the ON button on the panel to enable the remote commands from the MC.
Programming Notes:
1. PR1,2 Display as pressure (PR = Pressure)
FL1,2 Display as Flow (FL = Flow)
Signal Mode SM1,2 (2 = Independent, 4 = Slave)
Set RG (range) of each channel to configure pressure or flow.
Procedure:
Steps to run device:
Follow steps 1 and 2 if the device type is not already in your database
1. Follow steps of Add/Edit new device type
2. Enter Name “MKS4000b” and Relative Path “MKS4000b\MKS4000b.lvclass” and click on create/Modify Devicetype.
3.Then Add New PL1-PresCtrl-Low1 Device by following steps of Create New Device and Launch New Device
GUI exe path "\General GUIs\Device GUIs\GUI_PR4000_flow\GUI_PR4000_flow.exe"
4. Modify Devicetype Variable for PL1-PresCtrl-Low1 device
5. Launch local GUI from master control
6. GUI_PR4000_flow will open.
7. User can also set Devicetype variable values from GUI_PR4000_flow.