Picomotor8742

Introduction:

Install and run Picomotor8742 device on new computer.

Important Notes:

Operation Notes:

1. If the device is power cycled, manually turn on the valves and give a setpoint. After that press the ON button on the panel to enable the remote commands from the MC.

Programming Notes:

1. PR1,2 Display as pressure (PR = Pressure)

FL1,2 Display as Flow (FL = Flow)

Signal Mode SM1,2 (2 = Independent, 4 = Slave)

Set RG (range) of each channel to configure pressure or flow.

Procedure:

Steps to run device:

Follow steps 1 and 2 if the device type is not already in your database

1. Follow steps of Add/Edit new device type

2. Enter Name “Picomotor8742” and Relative Path “Picomotor8742\Picomotor8742.lvclass” and click on create/Modify Devicetype.

3.Then Add New P2-Pico Device by following steps of Create New Device and Launch New Device

GUI exe path "\General GUIs\Device GUIs\GUI_Beampointing_Pico\GUI_Beampointing_Pico.exe"