Sometimes sewer issues go undetected until they cause ruckus or damage to your home. As you can possibly imagine, sewer lines need even as much attention and maintenance as other parts of your home. However, we tend to overlook them because we do not know what we do not see. If you think something could be happening within your sewage system, you should look into it and decide immediately to get an inspection.

Inspection is one of the most important things you can give to your plumbing system. With inspection, you will be able to detect problems earlier and prevent further damage from happening. In this article, I am going to discuss the top most common sewer problems found during a sewer pipe inspection (a bit unexpected but better found than wait for damages).

Offset Pipes

Offset pipe is the term for sections of pipes that meet but do not line up correctly. Most of the time, an environmental change is typically guilty for an offset pipe. Settlement within the surrounding earth or root growth can cause the 2 sections of piping to shift independently. Occasionally the matter is thanks to poor installation, but this is often rare.

If the offset is little, and it doesn't appear to be blocking the flow of waste, then no action is required. But if the offset is larger and specifically if it is near rock bottom fringe of the pipe, then repair is needed. In that case, you have to call on an expert immediately. I would highly recommend a plumber in Belmont, NC. They can assist you with your needs and they have the best plumbers that can help you with your problems.

Flat Areas (aka) Belly

This is commonly referred to as sag, low area, or belly when debris collects in the low point and interferes with the flow of the system. This can cause a backup or blockage in your sewer main. A belly in your sewer main was likely the result of a poor layout for the sewer, or it has been impacted by other factors like a tree root invasion or shifting soil due to weather.

Minor belly problems where water is present does not always necessarily need a repair. In fact, a belly may be a quite common sewer pipe inspection issue. Your sewer line inspector will inform you if a belly is sloped enough to need action. However, it is always important to address the issue while it is still small than wait for it to grow big. The bigger the issue, the bigger the impact, and the bigger the cost will be.

In cases like the two mentioned above, it is important to address the issue properly and efficiently. As advised by professionals, always choose a plumber that provides a seamless installation because it will give you a great return of investment in the long run.