DC12: SKETCHING

LETTERS

The letter tool is located in the middle section of the sketch tool bar

Locate the Sketch where the lettering was created.
Edit the sketch
- DOUBLE LEFT CLICK on the name of the Sketch
- RIGHT CLICK on the name of the Sketch and select EDIT
- RIGHT CLICK on the geometry of the Sketch and select EDIT SKETCH
RIGHT CLICK on the text when it is highlighted in yellow and select EDIT TEXT
Make changes in the text box
LEFT CLICK on the the GREEN check box when done editing the text.
LEFT CLICK on the the GREEN check box when done editing the sketch.

Move the Cursor over the top or bottom line of the text box.
RIGHT CLICK on that line and select TRANSFORM SKETCH ENTITIES
LEFT CLICK on the Up arrow and hold to move the text UP and DOWN
- A size box will be shown to enter an exact distance moved if desired
- Enter the desired value
- LEFT CLICK outside of the part to set the distance
LEFT CLICK on the RIGHT arrow and hold to move the text LEFT and RIGHT
- A size box will be shown to enter an exact distance moved if desired
- Enter the desired value
- LEFT CLICK outside of the part to set the distance
LEFT CLICK on the ROTATE arrow and hold to ROTATE the text CLOCKWISE and COUNTER-CLOCKWISE
- a Degree box will be shown to enter an exact angle
- Enter the desired value
- LEFT CLICK outside of the part to set the rotational angle

Report abuse