430 stainless steel plates
Bolt m3 x 10 (12)
Nut m3 (12)
Magnets are fragile so hold each of them firmly and gently.
In this stage you don't have to fasten the nuts. You'll need to adjust the positions of magnets later when the front lower panel is attached.
Left/right/top PC panels for Tank v2
Rubber trim
Nylon rivet R5105
nylon standoff 9 x 5 x 3
nylon standoff 9 x 5 x 5
Wrap the rubber trim only at the red sides of the panels.
(Use the 5mm long standoffs if the frame pieces are inner. Use the 3mm ones if outer. More detailed desc TBD.)
430 plate ↔ front top panel
Bolt m3 x 08 (4)
Nut m3 (4)
Washer 3 x 8 x 0.8 (8)
Hinge ↔ frame
Hinge (3)
RH bolt m4 x 08 (6)
Nut m4 (6)
Front top panel ↔ hinge
RH bolt m4 x 10 (6)
Nut m4 (6)
Washer 4 x 9 x 0.8 (6)
430 plate ↔ front lower panel
Bolt m3 x 08 (12)
Nut m3 (12)
Washer 3 x 8 x 0.8 (12)
PTC heater
5015 fan
PTC heater mount (2) (STL here)
RH bolt M4 x 10 (8)
Nut M4 (8)
Assemble the PTC heater, 5015 fan and two mounts as shown in the picture and attach them to to frame.
(Beta version only)
You get a larger 6015 fan. Please rotate the fan 45° and attach it to the mount as shown in the last picture.
Please draw a 43mm x 122mm rectangle on the rear ACM panel as shown in the picture, and drill four larger 5mm holes for M4 bolts.
Image courtesy: Tank v2 owner Mike Simpson