Bandsaw Safety

Mark the line you're going to cut along

Set the blade guard to just above the material, about 1/8"

Place the workpiece flat on the bandsaw table, never held in the air

Keep your fingers clear of the blade AT ALL TIMES

If holding your workpiece puts your fingers too close to the blade, use a piece of scrap wood as a push stick

Apply gentle and steady force to move the workpiece into the blade. Too much force can damage the blade, and cause binding

Only start cutting when the blade is up to full speed

Never distract or crowd someone using a bandsaw

If you need to back out a cut, turn off the blade and wait for it to come to a complete stop before backing out your material

Do not adjust the bandsaw while it's running

Stay at the bandsaw until the blade comes to a complete stop