November Quiz and resources
Quiz is set for Thurs / Fri, Nov 8 / 9.
You'll need to know about how to use these tools and terms for the Nov Quiz.
Gents Saw
Tenon Saw
Jr. Hacksaw
Bench Hook
Disk Sander
Sanding Board
Sand Paper
PVA glue
Drill, Bit, and Chuck
Countersink, clearance, and pilot holes
Marking Gauge
Marking Knife
Try Square
Housing joint and Crosslap Joint
Chisel and Mallet
Square File, Round File, Flat File
Bench Vice
Lacquer
Thinner
Sliding Bevel
Screwdriver (Phillips and Flathead)
Pliers (Needle-nose or otherwise)
Not for Student Use . (but you should be familiar with these)
Band Saw
Drop Saw
Table Saw
We'll look at pages 5 thru 8 of the workbook to learn about the Design Cycle and how it's used.
Look at pages 14 thru 17 in relation to tools.
Sem 2 Quiz is set for Tues / Wed, April 16th / 17th
All tools and info above could be on the quiz.
A few extra things that the quiz may focus on.
- Gantt Chart and Flow Chart
- Design Specifications
- How to Render an Image in Fusion
- 3rd angle projection symbol
- The Evaluation Part of the Design Cycle