Smart Leak Detectors

Step by Step Guide

1. Power On the Device

• Screw the antenna onto the main device

• Press and hold the top left button for 5 seconds until the LED blinks, then release

• The device has connected successfully when the LED blinks green for 2 seconds

2. Select Probe Location

• Make sure the probe is tightly screwed onto the cable

• Choose where you want to detect leaks and place the probe there

• ⚠️ Note: Any section of the probe that water touches will trigger an alert

• Ensure the surface is clean and free of contaminants (debris, dirt, adhesives, water droplets, sharp objects, etc.)

Step 3 — Secure the Device

• Select a wall near where you placed the probe

• Mount the main device to the wall using double-sided tape or 2 screws

• If you need more cable length, contact Hexmodal support (up to 30 feet supported)

Step 4 — Scan & Register the Device

• Scan the QR code on the device using your camera or QR scanner to launch the Hexmodal dashboard

• Log in with your username and password

• Select Building and add a description for Location

• Optionally place the device on a floor plan by tapping its location

• Tap Save & Submit

Step 5 — Check Connection

• In the dashboard, scroll down to the Compliance Status tab

• If the device doesn't automatically connect, splash water onto the probe to trigger an alert

• If it still doesn't connect, contact Hexmodal support