Installing a Hexmodal Room Pressure Monitor

Step by Step Guide

1. Unbox and Identify Components

   • Hexagon-shaped device (temperature and humidity sensors)

   • Rectangular device (pressure sensor)

   • Mounting bracket, LED cable, and silicone tubing

2. Identify Installation Location

   • Install above 50 inches from the ground, ideally on a wall adjacent to a hallway.

3. Drill a Hole

   • Drill a 3/8 inch hole through the wall to the adjacent hallway.

4. Setup Pressure Sensor

   • Connect the LED cable and silicone tubing to the pressure sensor.

   • Ensure an airtight seal.

5. Feed Wires Through the Hole

   • Use the provided wire to guide the cables through the hole.

   • Screw the pressure sensor into the wall.

6. Install Hexagon Device Inside the Room

   • Feed the tubes through the hole in the mounting bracket (marked "This Side Up").

   • Screw the bracket onto the wall.

7. Connect the Sensor

   • Pull the battery tabs to activate the hexagon device.

   • Connect the LED cable and tubing to the hexagon device.

   • Secure the device to the bracket.

8. Final Checks

   • Ensure the setup is secure and functional.